Zibro SC 3050, Installation Manual

Page: 8 / 22

INDOOR UNIT INSTALLATION
1. Fit the installation plate
1. Fit the installation plate
a
horizontally on structural parts of the wall with spaces around the installa-
tion plate.
2. If the wall is made of brick, concrete or the like, drill eight (8) 5mm diameter holes in the wall. Insert
Clip anchor
b
for appropriate mounting screws
c
.
3. Fit the installation plate
a
on the wall with eight (8) type “A” screws
c
.
G
NOTE
Fit the Installation Plate and drill holes in the wall according to the wall structure and
corresponding mounting points on the installation plate. (Dimensions are in “mm” unless
otherwise stated)
270~370
878
659 133
40
40
270
27 6
55
55
39
70
750
45
250
70
---
---
---
---
---
---
---
---
293
920
50
50
815
40
285
90
40
45
---
---
---
---
---
---
---
---
Correct orientation
of Installation Plate
G
ATTENTION
Copper lines must be insulated independently from each other.
G
ATTENTION
This illustration is for explanation and indication purposes only. The illustration may be different
from the airconditioner you purchased.
CAUTION
• Ensure that the space around the left and right of the indoor unit is more than 12cm.
The indoor unit should be installed allowing a minimum clearance of 15cm from the ceiling.
• Use a stud finder to locate studs to prevent unnecessary damage to the wall.
• The indoor unit should be installed on the wall at a height of 2.3 metres or more from the
floor.
• At least two of the directions A, B and C should be free from obstructions.
4
68
instal_S(C)30xx.qxd 19-07-2010 13:32 Pagina 68