Assembly
Following the assembly directions below, you will assemble the snow thrower in a few minutes.
Handlebars
1 Align the holes in the handle with the side plates and secure lower handle with the
screws and the washers until they are finger tight.
2 Keep the lower handle level and tighten all four screws.
3 Raise the handlebars into operation position and secure the handlebars with three
M8X45 screws, washers and nuts until they are finger tight.
4 Ensure that the handles are at the same height, then tighten all fastening ele-
ments.
Tires (if present)
The tires are over-inflated at factory for shipping purposes. Check the pressure in the tires. Reduce or Increase equally in both tires to
the manufacturer’s recommended pressure.
m
Under any circumstance do not exceed manufacturer’s recommended pressure. Excessive pressure when seating beads may
cause tire/rim assembly to burst with force sufficient to cause serious injury. Refer to side wall of tire for recommended pressure.
m
Equal tire pressure should be maintained at all times. If the tire pressure is not equal in both tires, the machine may not travel in a
straight path and the scraper blade may wear unevenly.
m
Keep tires free of gasoline and oil, which can harm rubber.
Skid Shoes
1 Move the machine to a level surface.
2 Support the auger blades so that they are 3mm (1/8”) off the ground.
3 Check the scraper blade adjustment. The scraper blade should be 3mm (1/8”)
above and parallel to a level ground. To adjust the scraper blade, loosen the
mounting screws, level the scraper blade, and tighten the mounting screws.
38
D
GB
Summary of Contents for Yellow GARDEN LINE 720 YGL N.G. NEW...
