ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 35 / 160

SET-UP PROCEDURES
Page 27
6.0 SET-UP PROCEDURES
The following Set-up Procedures are written with all options
considered. Not all options may be used on all Processors. Read
the Sections that relate to the application being used on this ves-
sel.
The CruiseCommand Processor has several functions that need
to be set-up for each application. Please read each function set-
up thoroughly before beginning set-up of the function.
6.1 P
ROCESSOR
C
OMPONENTS USED IN
S
ET
-
UP
6.1.1 Processor Display
The Processor Display has four 7-segment pads, which light up to show
either Letters or Numbers. (Refer to Figure 23:) This Display during Nor-
mal Operation has running center red dash lines.
• The first two digit pads indicate the Function Code, which is alphanu-
meric.
Figure 22: Processor Display and Arrow Push Buttons
Each CruiseCommand Processor has a
Display and Arrow Push Buttons located
on the front cover. (refer to Figure 22:)
• The Display is to view the Function
Codes and Values. Refer to Section
6.1.1.
• The Arrow Push Buttons are used to
scroll through and select the Func-
tion Codes. Also to scroll through
and set the Values. Refer to Section
6.1.2.
Figure 23: Display 7-Segment Pads