ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 105 / 272

SET UP
Page5-29
This Function may be used during troubleshooting.
(Do not make any adjustments to this Function
Code, unless directed to do so by ZF Mathers Ser-
vice or Engineering Departments).
5-6.5.2 Additional 9000 Series Troubleshooting Function
5-6.5.2.1 Function Code H2 - Driver Fault Detection Enable
The H2 Function is available only on Processors with
integrated Clutch and/or Troll Solenoids (i.e. 9120,
9121, 9122, and 9221).
The Processor can be programmed to monitor the
current flow through the clutch and/or Troll sole-
noids. When this option is selected, if the current
level is too high or too low, an alarm is sounded and
an Error Code is produced.
Table 5-1: lists the required value that needs to be
entered to monitor the Ahead, Astern, Neutral, Troll
Command, and Troll ON/OFF solenoids.
NOTE: F
UNCTION
C
ODES
32
THROUGH
63
ARE RESERVED FOR FUTURE EXPANSION AND SHOULD NOT BE
USED AT THIS TIME
.
Table 5-1: Solenoid Error Status Enable
Ahead Astern Neutral Troll Command Troll On/Off Value
0 0 0 0 0 00
1 0 0 0 0 01
0 1 0 0 0 02
1 1 0 0 0 03
0 0 1 0 0 04
1 0 1 0 0 05
0 1 1 0 0 06
1 1 1 0 0 07
0 0 0 1 0 08
1 0 0 1 0 09
0 1 0 1 0 10
1 1 0 1 0 11
0 0 1 1 0 12
1 0 1 1 0 13
0 1 1 1 0 14
1 1 1 1 0 15
0 0 0 0 1 16
1 0 0 0 1 17
0 1 0 0 1 18
1 1 0 0 1 19
0 0 1 0 1 20
1 0 1 0 1 21
0 1 1 0 1 22
1 1 1 0 1 23
0 0 0 1 1 24
1 0 0 1 1 25
0 1 0 1 1 26
1 1 0 1 1 27
0 0 1 1 1 28
1 0 1 1 1 29
0 1 1 1 1 30
1 1 1 1 1 31