Zezriderz BANDIT X, User Manual

Page: 17 / 23

is a possibility of ignition. Therefore, you should avoid charging for a long
time without a person, and charging must be done while the person is aware
that the risk of unexpected fire can be avoided.
6) Misuse
If the lithium battery is short-circuited or the polarity is changed, or if the
battery is impacted, malfunction or fire may occur. If you think that the
battery has been impacted, you should stop charging and using it and visit
the nearest point for inspection.
7) Water inflow
It should be controlled to prevent water inflow into the lithium battery. There is
a risk of fire or electric shock if the charger is connected while moisture
is present.
8) Caution Disconnect
The battery from the main unit and prohibit recharging, reinstalling, or using
other applications.
9) Disposal Disposal (When disposing of the lithium battery, the battery should be
separated from the product at the point of purchase or near the point so that
the charge and discharge terminals are not short-circuited. Dispose of it as
industrial waste when disposing of it.
Danger !
Battery disassembly prohibited : Battery disassembly,modification and repairment
are not covered under warranty.
09.Safety guidelines before driving
1) Required checking before use
Step1: Check throttle and handle
*Operate the accelerator throttle lever about 2 ~ 3 times to check whether it
returns to the home position.
*Be careful that excessive throttle Leaning and manipulation of the throttle can
cause malfunction due to internal parts damage.
*Check the fastening condition and clearance of the QR lever on the handle.
Step2:Check brake and cable
* The brake braking force is sufficient to check the operating condition. If the
braking force is significantly lowered, use it immediately after inspection
and action.
*Check that the brake pad is not worn, that the cable is not loose, that the cable
is not damaged.
*If there is an unusual feeling or noise during operation, check for breakage,
wear and deformation of the inner wire of the brake cable.
*Check that the bolts and nuts of the brake fixing parts are not loose.