---------------------------------------------------------------------------------------------------------------------------------------------------------
7
Note:
When sending commands or data, status check must be performed. Otherwise, T6963C
can’t operate normally, even after a delay time.
For the details of the commands and T6963C operate please refer to T6963C datasheet.
10.
DESIGN AND HANDING PRECAUTION
10.1.
The LCD panel is made by glass. Any mechanical shock (eg. Dropping form high
place) will damage the LCD module. Do not add excessive force on the surface of the
display, which may cause the Display color change abnormally.
10.2.
The polarizer on the LCD is easily get scratched. If possible, do not remove the LCD
protective film until the last step of installation.
10.3.
Never attempt to disassemble or rework the LCD module.
10.4.
Only Clean the LCD with Isopropyl Alcohol or Ethyl Alcohol. Other solvents (eg.
water) may damage the LCD.
10.5.
When mounting the LCD module, make sure that it is free form twisting, warping and
distortion.
10.6.
Ensure to provide enough space(with cushion) between case and LCD panel to
prevent external force adding on it, or it may cause damage to the LCD or degrade the
display result
10.7.
Only hold the LCD module by its side. Never hold LCD module by add force on the
heat seal or TAB.
10.8.
Never add force to component of the LCD module. It may cause invisible damage or
degrade of the reliability.
10.9.
LCD module could be easily damaged by static electricity. Be careful to maintain an
optimum anti-static work environment to protect the LCD module.
10.10.
When peeling of the protective film form LCD, static charge may cause abnormal
display pattern. It is normal and will resume to normal in a short while.