ZETRON 4010, Programming Manual

Page: 46 / 117

Section 4. Program Operation
B. Position Layout
This selection allows expansion panels to be incorporated into the Model 4010 configuration.
Figure 4-7 is displayed if this selection is pressed. Panel #2 or #3 are the only options that are
available. Once either 2 or 3 is entered Figure 4-x2 is diplayed. Panel 2 must be entered
before Panel 3, or an error message is displayed. Figure 4-x2 allows the operator to select A,
B, or C, to indicate a 4115, a 4015, or a 4011 console expander. After a selection is made, the
CPS display (Figure 4-7) is updated to indicate which expansion panel has been added to the
configuration.
Once an expansion panel has been added, the “A. Key Definition” selection shown on page
4-4 will indicate this new configuration and allow expansion panel data to be added.
Panel #0 Main Upper
Panel #1 Main Lower
Panel #2 Undefined
Panel #3 Undefined
Select Panel 2 or 3 [2]
Figure 4-7. Position Layout
D. Model 4115 Console Expander
E. Model 4015 Console Expander
F. Model 4011 Console Expander
Select Model [A]
Figure 4-8. Position Layout Sub-Panel
C. Audio Controls
This function sets various volume levels and speaker muting options for the system. Select
E
from the MAIN menu, and then select P to display the next menu. Select C and the AUDIO
CONTROLS menu will be displayed.
The following list describes the seven selections on the AUDIO CONTROLS menu.
1.
2.
Muted Audio Level
Select option
A from the AUDIO CONTROLS menu. Enter a number from 0 to 99
representing the percentage of total volume to be used as a muted audio level for all
channels of the system. The percentage entered will be rounded up to the nearest
integer multiple of 12.5.
Minimum Audio Level
Select option
B
from the AUDIO CONTROLS menu. Enter a number from 0 to 99
representing the percentage of total volume to be used as a minimum adjustable audio
4-10 025-9229C.1