77
PTT Handset with Cradle
PTT Handset with Cradle
The PTT Handset (P/N 950-9315) may be used with the Model 4010 Console. When
installed in the field, the handset cradle must be mounted to the side of the console using
the four mounting holes provided. See
for details.
The connector with wires from the switch hook is installed on P3, which is on the Control
Board under the handset cradle mounting location. The four-wire modular cord from the
handset is installed in the modular connector on the exterior side of the console near the
handset cradle.
Figure 13: Handset Cradle Assembly
2 PLCS
6
7
TO P3
10 PLCS
2
1.
8
5
4
INSTALL PINS AND HOUSING ON OTHER END OF WIRES.
EACH WIRE TO HOOKSWITCH TERMINALS AS SHOWN.
1. CUT WIRE INTO 2 6" PIECES. SOLDER ONE END OF
11
NOTES:
ITEM
QTY.
PART NUMBER
DESCRIPTION
1
2
220-0200
SCREW, 6-32x1", PAN, PHL, S-Zn
4
2
234-0017
WASHER, STAR, #8, CTSK, SS
3
2
234-0011
WASHER, LOCK, SPLIT, #4, S-Zn
7
1
401-0083
CONN,CRIMP TERM HOUSING,2 POS
6
2
401-0082
CRIMP TERM
5
2
251-3473
SPACER,RND,#8x1/2",.25"OD/.171"ID
11
1
802-1078
UNIVERSAL HOOKSWITCH
10
1
802-0097
HANDSET, PTT
9
1
709-0002
HANDSET CORD, 4-WIRE
8
12"
408-2201
WIRE, 22AWG (19x34) PVC, WHITE
2 PLCS
ON CONTROLLER BOARD
2 PLCS
MODEL 4010 CHASSIS
VIEWED FROM REAR
PART OF
802-1078
1
2. DISCARD PANHEAD SCREWS (2), LOCKWASHERS (2),
AND HEX STANDOFFS SUPPLIED WITH 802-1078.
2
10
234-0006
WASHER, FLAT #6 STEEL ZINC
3
2 PLCS
