Zetor UTILIX CL, Operator'S Manual

Page: 66 / 136

Upper Link Adjustment
1
- Upper Link
2 - Length Adjustment Handle of the Upper Link. Extending or shortening the upper link changes the angle of
the implement.
Adjustment of the stabilizer bars
Adjustment of the lower links of the three-point hitch
After adjustment, secure the adjustment handle with its
mounting nut.
U18N043
The locating hole of the top link varies with the type of
implement used.
1) The most common locations are the 1st and 2nd hole
from the top (1).
2) For general implement: Use the Pin to
Position 3 point.
3) For Draft control: Use the Pin to Position 2 point.
U18N044
The stabilizer bars are designed to limit or prevent lateral
movement of the implement.
No clearance is permitted when transporting implements
and when working on slopes, with rollers, mowers,
seeders, drills and similar implements (
position 1 ).
However, a slight clearance ( position 2 ) is necessary
when working with plows, harrows, excavators, cultivators,
etc., especially when working with draft control.
The length of the stabilizer bars is adjusted after removal
of the pin by turning the tensioner through which the
threaded plugs are connected.
UCL18N037
1 - Vertical link
Adjustment is made using the adjustment handle of the
right vertical link.
Turn the handle clockwise to retract and turn the handle
counterclockwise to extend.
After proper adjustment, secure the handle against
spontaneous rotation.
UCL18N040
TRACTOR CONTROLS
65