4
ALARM CIRCUIT MODULE INSTRUCTION MANUAL
Power on Procedure
1.
After the above has been completed, turn the panel on (Via AC Only). The panel will follow the same power up
sequence described in initial power up section above
2.
The panel will now display one of the following messages
Message
Meaning
Panel has not detected any modules fitted
during its power up check.
Power down the panel and check that the
expected modules are fitted, and that all
module cables are correctly inserted.
Note that the panel will need at least one
module fitted to run.
The panel has detected a new module added
to a port that was previously empty.
This is the usual message seen the first time a
panel is configured
The panel has detected a different type of
module fitted to a port that was previously
occupied.
The panel has detected a module fitted to a
port that is the same type, but it`s serial
number has changed.
This could happen if a loop module was
swapped with another one, for example.
The panel has detected no module fitted to a
port that was previously occupied.
The panel has detected no module changes, so
has powered up and started running
