Zeta Alarm Systems ZS-H2S/500, Manual

Page: 15 / 16

Calibration and Bump Testing
Gas detectors should be functionally tested regularly to ensure their
correct operation. This is referred to as bump testing.
To bump test a Zeta Gas Sense detector, fit the Calibration cap to the stainless
steel filter housing. Then take a test Cylinder with the appropriate gas type &
concentration. Fit the tube from the cylinder to the Calibration cap . Open the
regulator on the cylinder. Check that the reading on the detector rises and reaches
the level indicated on the cylinder (Within the specified tolerance range)
If a detector fails this bump test then it should be zero’s in clean air then
recalibrated using the calibration cap and the gas cylinder.
Test Gas Cylinders
A range of cylinders are available for testing the Gas Sense detectors.
Gas Type H2S H2S H2S NH3 CO NO2 O2
Volume Of Test Cylinder 34 Litres 34 Litres 34 Litres 34Litres 34 Litres 34 Litres 34 Litres
Test Gas Concentration 250 ppm 100 ppm 50 ppm 500 ppm 50 ppm 10 ppm 150 ppm
Part Number 31650-3-1 31650-4-1 31650-5-1 31650-7-1 31650-6-1 31650-2-1 31650-1-1
Pressure 500PSI 500PSI 500PSI 500PSI 500PSI 500PSI 500PSI
Other gasses & concentrations are available on request.
15