3)
Place Roof (Item F) across both sides evenly and using a spirit
level
ensure end panels are straight.
With
a tape measure, measure from outside of roof measure 70mm in
,
this is the external overlap.
Using 3mm drill bit drill all four corners as shown in the photograph using 4x60 screws
(Item
B)
Place in pre drilled holes.
4)
Place Back corner supports
(Item
E) as shown in photograph. Pre drill holes
with
3mm drill bit.
Using two 4x60mm screws
(Item
B) screw brackets into place. Repeat on opposite side.
The assembly is now complete.
