ZEROXCLUB Instructions Manual
4
TEST THE SYSTEM
To ensure that all components are working properly, please test the
system before installation.
1. When the monitor is powered, the screen will light up to indicate that the
monitor is on and ready to work.
2. The green indicator light of the camera comes on, which indicates that the
backup camera is turned on and ready to work.
3. Camera and monitor come pre-paired. The monitor will display the camera
image. If not, please refer to the troubleshooting and contact our customer
service at
.
NOTICE
：
1) Please fully charge the backup camera with USB cable before first use.
The solar panel can be used as a tool to supply power to the battery,
extend the working time of the backup camera and reduce the charging
times. But you need to charge the backup camera with USB Charging
regularly according to the frequency of use, especially in the winter.
2) If the product has been installed, you can charge the battery by USB cable
using a mobile power supply or jumper starter instead of moving it from
your vehicle. Or you can remove the camera and then charge it.
3) Many vehicles provide constant power to the 12V outlet. If your outlet
provides constant power, please remember to unplug the monitor when
not in use to avoid draining the vehicle battery.
4) If the battery indicator bar shows that the battery is in a low state of charge,
please charge the battery in time. (Charging frequency depends on the
using environment and frequency of utilization.)
5) If you use a power bank or a jump starter to charge the device, make sure
that its battery capacity is no less than 6400mAh.
6) By default, the monitor will stop displaying images and enter into standby
mode after 45 seconds. You can adjust the "on" time.
7) The camera comes with a Smart button so you can manually turn on the
screen/camera. When the screen is in standby, press any button can
activate the screen/camera.