zero
HOME AUTOMATION
PG7
ZPORTAV230 | CONTROL PANEL | PORTA 230V
SAFETY INSTRUCTIONS
STANDARDS TO FOLLOW
• To ensure the safety of people, it is important that you
read all the following instructions. Incorrect installation or
incorrect use of the product can cause physical injury and
material damage.
• Keep these instructions in a safe place for future refe
-
rence.
• This product was designed and produced strictly for the
use indicated in this manual. Any other use, not expres
-
sly indicated here, could compromise the good condition/
operation of the product and/or be a source of danger.
• ZERO SRLS is not responsible for the improper use of the
product, or other use than that for which it was designed.
• ZERO SRLS is not responsible if safety standards were
not taken into account when installing the equipment, or
for any deformation that may occur to it.
• ZERO SRLS is not responsible for the safety and proper
operation when using components not sold by them.
• Do not make any modifications to the operator compo
-
nents and / or their accessories.
• Before installation unplug the automatism from the
source of power.
• The installer must inform the client how to handle the
product in case of emergency and provide this manual to
user.
• Keep remote controls away from children, to prevent
the automated system from being activated involuntarily.
• The customer shall not, under any circumstances, at
-
tempt to repair or tune the automatism. Must call quali
-
fied technician only.
• Connect the automatism to a 230V plug with ground
wire.
• Control board for indoor use.
THE CONTROL BOARD
TECHNICAL SPECIFICATIONS
Power supply:
230V 50/60Hz
Motor’s output:
AC230V 1350 W max
Aux. accessories
output:
AC12V-1W- 80mA máx
Working temperature:
-20°C a +50°C
Radio Receptor:
Incorporated 433,92 Mhz
OP Transmitters:
Rolling Code
Max. memory capacity:
50 codes max
CONNECTOR’S DESCRIPTION
CN1 Connector
01 • LINE INPUT NEUTRAL
02 • LINE INPUT PHASE 230V
03 • MOTOR OUTPUT CLOSE
04 • MOTOR OUTPUT OPEN
05 • MOTOR COM
CN2 Connector
06 • POWER SUPPLY OUTPUT 12Vdc
07 • POWER SUPPLY OUTPUT 0Vdc
08 • PHOTOCELLS INPUT (NC) - PHOTO
09 • COM CONNECTION
10 • OPEN PUSH BUTTON (NO) - START
11 • SAFETY EDGE 8.2KOHM (NC)
OPTION (configuration with brake relese PORTA SB)
12 • BRAKE INPUT (+12V)
13 • COM CONNECTION
14 • BATTERY (0V)
15 • BATTERY (12V)
PROGRAMMING PRE-RECOMENDATIONS
Before proceeding to the control board configuration,
note the following points listed in the table below in order
to better understand the control board function:
Motor:
03 and 04 The motor phases must be connected in these
two terminals. If the motor direction is the opposite to the
desired simply switch the two wires to reverse direction.
Security circuit - Photocells:
09 (COM) and 08 This circuit allows connection of all pho
-
tocells types. This device intervenes only during closure.
In pause time When it is activated during closing maneu
-
vers, it stops and starts a complete automatism opening.
Mecanic push-button:
09 (COM) and 10 This circuit allows the connection of
mechanical push-buttons with two button for opening
and closing. NOTA You can, with a one button’s push-but
-
ton , control the opening and closing of the automation
in step mode (open-stop-close-stop (...) always with the
same button.
