912-A Pancho Road • Camarillo, CA 93012
Tel: 800-345-9791
Fax: 805-388-8285
Honda CBR250R (11-12) DIY Windscreen Install
2
install 443-IS
Remove two pop rivets on either side of the bike. Set
aside the 4 total pop rivets .
Removing Pop Rivets
Dislodge the keeper by using a needle nose pliers
pinch the plastic and pull away. Feed the wire loom
back into the fairing hole.
Detaching Wire Loom Keeper
Removing Gauge Cluster / Screw & Retention Clip locations
Unscrew the allen screws, and pull up on retention clips area when pulling cluster off.
Apply even pressure from the backside to dislodge retention clips shown above. Pull
away from fairing.
Caution:
Electrical wires are connected to the dash.
Unplug
connector from dash assembly.
Set aside the gauge cluster.
Detach the fairing wires and set side fairing aside.
Note:
Upon reattaching wires, match the wire colors.
Attaching and Detaching Wires
How to remove and install pop rivets on the bike.
To remove these simply use a blunt point like a phillips
screw driver and press in the middle circle as shown
on the right. To install, prep the pop rivets as shown on
the left and simply press the middle circle to fasten.
Should be flush if done correctly.
Pop Rivets
Remove
both sides
Pinch both
sides
Feed the wire
loom into hole.
Retention clip
Retention clip
Note:
Allen screws have
a step on the bot-
tom shoulder, fine
thread.
