3
Author: Rudi
Version: 2.2
Revision: 1.3
Revision Date: August 2020
INSTALLATION INSTRUCTIONS:
IMPORTANT INFORMATION FOR THE USER
Only a registered LP Gas installer may install a gas installation. All registered installers
are issued with a card carrying their registration number. Ask to be shown the card before
allowing the installation work to commence and make a note of the Installer QCC number.
Upon completion of the installation, the installer is required to explain the operational
details of the installation together with the safety instructions. You will be asked to sign
acceptance of the installation and be provided with a completion certificate. You should
only sign for acceptance of the installation when the installation is completed to your
satisfaction.
Note: Your invoice is required in the event that you wish to make a guarantee claim.
WARNING: ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN
CONTACT WITH OR NEAR THE BURNER BOX.
IMPORTANT INFORMATION FOR THE INSTALLER.
Only an LP gas installer registered with the Liquefied Petroleum Gas Association of South
Africa may install a gas installation. The installation must be installed in accordance with
the requirements of SANS 10087-1 and any fire department regulations and/or local bylaws
applicable to the area. If in doubt, check with the relevant authorities before undertaking the
installation. Upon completion of the installation, you are required to fully explain and
demonstrate to the user the operational details and safety practices applicable to the
installation and the appliance.
1.
ENSURE THAT THE APPLIANCE IS STANDING LEVEL!
If positioning on uneven or soft ground, place two flat pieces of wood or
suitably hard material (approximately 600mm long and 100mm wide by
20mm thick) under the two feet of the appliance, from front to back, before
attempting to level the appliance.
2.
Place the appliance in a cool, well-ventilated area out of direct sunlight and
strong gusts of wind, allow enough space (at least 100mm) around sides
and back of appliance and 600mm above the appliance.
3.
Remove all loose items from the appliance
