Zepter Vital Systems PBG-865, Instruction Manual

Page: 4 / 40

5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
10
9
8
4 5
Instructions for use: Using the Epilation Head:
1. Use your
Zepter Hair Remover
in a location that has a comfortable
temperature to avoid perspiration.
2. Make sure that the areas you wish to remove hair from are clean, dry
and free from moisturizing cream or oil.
3. To use your unit as a cordless device, plug it into an electrical outlet
and let it initially charge for 16 hours. After the initial charge you can
use it until you notice that it is losing power. Then recharge your unit
for 8-16 hours, depending on battery power (fig 1-4).
4. If your unit is not charged, insert the adapter plug into the bottom
of the unit and plug your adapter into an electrical outlet.
1. Remove the protective cap, by gently
pulling, from your
Zepter Hair Remover
(fig 5).
2. Turn your unit to the desired speed, low
is recommended for fine hair and high is
recommended for coarse hair (fig 6).
3. To minimize discomfort, hold the
skin taut surrounding the area you are
removing hair from (fig 7).
4. Position your
Zepter Hair Remover so
that it is vertical against your skin, at a 90°
angle (fig 8).
5. Keep the stainless steel tweezers upright;
the
Zepter Hair Remover logo should be
facing away from you.
6. Gently glide the
Zepter Hair Remover
in
short, quick, brush like or sweeping
strokes in the direction of hair growth (fig 9).
Note: For you protection, your Zepter Hair
Remover
may slow down, or stop operating
completely if it is pressed too hard against
the skin.
7. If it has been an extended amount
of time since you have removed hair from
you bikini line and underarms, trim the
hair with scissors or a trimmer. Make sure
to hold the skin taut with one hand while
removing hair.
8. The
Zepter Hair Remover
is only
intended to remove individual hairs from
the upper lip (fig 10), chin and cheek area.
When removing hair from these
sensitive skin areas please hold the
surrounding area taut. Do not use this unit
by the eyebrows, forehead or hairline.
On the Back of the Knee
Straighten your leg so that the skin is held taut
and hold the
Zepter Hair Remover
so it is vertical
against your skin, at a 90° angle.
2
1
3
4
EN EN
For best results:
Take a warm bath or shower, to open up your pores, and use a loofa sponge or exfoliation cream
in small circles to remove dead skin from the area you wish to remove hair. Doing this before you
use your
Zepter Hair Remover will cleanse and make your skin pliable, so removing hair will be
less uncomfortable.