Zepter Edel Wasser PWC-670-BLACK, Instruction Manual

Page: 15 / 100

EN
27
EN
Rated Capacity
681.4 L (180 gallons) - (for VOC)
16655.8 L (4 400 gallons) - (for Aesthetic Chlorine)
Min-Max operating pressure: 138kPa ~ 827kPa (20 psi ~ 120 psi)
Min-Max feed water temperature: 5 ºC ~ 35 ºC (41ºF ~ 95 ºF)
Rated Service Flow 0.26 L/min (0.07 GPM)
Daily Water Production Rate* 168.5 L/d (44.5 GPD)
Product Efficiency Rating* 20.7 %
Substance
Max.
Allowable
Concentration
(mg/L)
Average
Influent
(mg/L)
Average
Effluent
(mg/L)
Minimum
Percent
Reduction (%)
Average
Percent
Reduction
(%)
Arsenic (Pentavalent) 0.010 0.0511 0.001 93.9 97.8
Barium 2.0 11.4 0.309 93.1 97.3
Radium 226/228 5 pCi/L 25 pCi/L 5 pCi/L N/A N/A
Cadmium 0.005 0.035 0.00056 95.8 98.4
Chromium (Hexavalent) 0.1 0.324 0.00446 95.9 98.6
Chromium (Trivalent) 0.100 0.281 0.00174 98.4 99.4
Lead 0.010 0.201 0.00149 98.1 99.3
Copper 1.3 3.223 0.063 96.4 98.0
Selenium 0.05 0.121 0.00192 96.9 98.4
TDS <187.5 751.8 57.8 91.4 92.3
Aesthetic Chlorine ≥ 50% reduction 2.07 0.56 54.53 72.8
VOC* ≥ 95% reduction 0.3274 0.0008 94.3 99.7
WATER FILTRATION SYSTEM
PERFORMANCE DATA SHEET
BRAND: ZEPTER INTERNATIONAL - MODEL: PWC-670
This system has been tested and certified by the Water Quality Association according
to NSF/ANSI 42, 53, and 58 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a
concentration less than or equal to the permissible limit for water leaving the system, as
specified in NSF/ANSI, 53, and 58.
While testing was performed under laboratory conditions, actual performance may vary.
GENERAL OPERATING INFORMATION:
*Daily Water Production Rate and Product Efficiency Rating can be differentiated according to the inlet
water pressure and water temperature.
Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
• Refer to the owners manual for specific installation instructions, manufacturer’s
limited warranty, user responsibility, and parts and service availability.
• The influent water to the system shall include the following characteristics:
- No organic solvents
- Chlorine: < 2 mg/L
- pH: 7 - 8
- Temperature: 5 ºC ~ 35 ºC (41 ºF ~ 95 ºF)
- Iron: < 2 mg/L
- Turbidity: < 1 NTU
- Hardness: < 1 000 mg/L
• For parts and service availability, please contact your local Zepter dealer.
• This system has been tested for the treatment of water containing pentavalent
arsenic (also know as As(V), As(+5), or arsenate) at concentrations of 0.050
mg/L or less. This system reduces pentavalent arsenic, but may not remove
other forms of arsenic. This system is to be used on water supplies containing
a detectable free chlorine residual at the system inlet or on water supplies
that have been demonstrated to contain only pentavalent arsenic. Treatment
with chloramines (combined chlorine) is not sufficient to ensure complete
conversion of trivalent arsenic to pentavalent arsenic. Please see the Arsenic
Facts section of this Performance Data Sheet for further information.
• Efficiency rating means the percentage of the influent water to the system
that is available to the user as reverse osmosis treated water under operating
conditions that approximate typical daily usage.
• The product water should be tested every 6 months to ensure that the
contaminants are being reduced effectively. Please contact your local Zepter
dealer. to initiate this service.
• This reverse osmosis system contains a replaceable treatment components,
critical for the effective reduction of total dissolved solids and that product
water shall be tested periodically to verify that the system is performing
properly. Replacement of reverse osmosis component should be with one of
identical specifications, as defined by the manufacturer, to assure the same
efficiency and contaminant reduction performance.
• The estimated replacement time of filter, which is a consumable part, is not
an indication of quality guarantee period, but it means the ideal time of filter
replacement. Accordingly, the estimated time of filter replacement may be shortened in
case it is used in an area of poor water quality.