2
4.
Preparation before Starting
1,
Remove compressor from outer
packaging
2,
DO NOT REMOVE TRANSIT PLUGS
BEFORE FITTING THE WHEELS.
3,
Lie compressor on side to fit wheels and
dampers
4,
Allow 5-10 minutes once compressor is
upright before starting.
5,
Remove transit plugs and insert air filters
supplied
6,
Insert oil breather plug supplied
7,
The ideal place to set the compressor should be
clean, dry and well ventilated.
8,
Keep the use voltage or – 5%.
9,
Keep the oil level within the red circle of the oil site
glass.
10,
The recommend compressor oil is SAE30 over 10
deg, and SAE10 below 10 deg.
11,
Set the pressure switch to the On position (Fig.2), let the
compressor run for 10 minutes with no load to ensure
lubrication of the moving parts before regular operation.
5.
Operation and Adjustment
1,
The compressor is controlled by a pressure
switch when in use. It will stop automatically
as pressure increases to the max setting, and
restart as pressure is reduced to the min setting.
The pressure switch pressure rating has been
set from factory and shouldn’t be adjusted
unnecessarily.
2,
The outlet pressure of the compressed air can
be adjusted by the regulator valve. Rotate the knob on the
regulator by turning the regulating knob clockwise or
anticlockwise to increase or decrease air pressure.
3,
To turn compressor off, press the red knob down to the Off
position.
Summary of Contents for ZC350
Page 7: ...5 9 Parts Diagram...
