Zephyr MWD2401AS, Use, Care And Installation Manual, Page: 20 / 64

20 MWD2401AS Use, Care, and Installation Guide
M I C R O WAV E
D R AW E R
B U I LT- I N
Operating Your Appliance
Using the Control Panel
TIME
COOK
+30
SEC.
DEFROST
POPCORN
MELT
SOFTEN
CHILD
LOCK
SENSOR
REHEAT
BEVERAGE
CLOCK
KITCHEN
TIMER
SENSOR
COOK
POWER
MUTE
ON/OFF
5
0
4
9
3
8
2
7
1
6
CANCEL
STOP
START
PAUSE
CLOSE
OPEN
(1) (2) (3) (4) (5) (6) (7)
(8) (9) (4) (11) (10)
(12) (13) (14)
(15) (16) (13)
STANDBY MODE
When the microwave drawer is first plugged into an outlet, an alarm will sound. The screen will
display “WELCOME”. Then, the microwave drawer defaults to standby mode. Standby mode is
defined as being idle and not being operated for cooking.
The screen will display “00:00”. In standby mode, the screen will display the current time if the clock
has been set. Otherwise, “00:00” will display.
OPEN & CLOSE
Allows you to open and close the microwave drawer with ease.
1. Press the OPEN button to open the microwave drawer. The screen will display “OPEN”.
2. Press the CLOSE button to close the microwave drawer. The screen will display “CLOSE”. The
screen will display the current time or “00:00” when the microwave drawer has fully closed.
Manually pushing to close the microwave drawer is also acceptable.
NOTE: The microwave drawer automatically opens by pressing the OPEN button and automatically
closes by pressing the CLOSE button. However, pressing the OPEN or CLOSE button during
this process will stop the door from opening or closing. Pressing the OPEN or CLOSE button
again will resume the process.
CLOCK
The clock shows the time under a 12-hour display and can only be set in standby mode. To reset the
clock, repeat the steps below:
1. Press the CLOCK button, and the screen will display “12:00”.
2. Press the number keys to enter the correct time. The input time should be between 1:00 - 12:59.
3. Press CLOCK or START/PAUSE to finish the setting, indicated by a flashing “:”.
►
Pressing the CANCEL/STOP button or waiting a minute while setting up the clock will cause
the microwave drawer to revert back to its former time.