6
Milano Use, Care, and Installation Guide
M I L A N O
WA L L
C O R E
Safety Information
Operation
Ź
Always leave safety grilles and filters in place. Without these components, operating blowers could catch onto hair, fingers and
loose clothing.
Ź
The manufacturer declines all responsibility in the event of failure to observe the instructions given here for installation,
maintenance and suitable use of the product. The manufacturer further declines all responsibility for injury due to negligence and
the warranty of the unit automatically expires due to improper maintenance.
NOTE:
Please check www.zephyronline.com for revisions before doing any custom work.
Electrical Requirements
Important:
Ź
Observe all governing codes and ordinances.
Ź
It is the customer’s responsibility to be aware of these below:
Ź
To contact a qualified electrical installer.
Ź
To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 latest
edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and all local codes
and ordinances.
Ź
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path
is adequate.
Ź
Do not ground to a gas pipe.
Ź
Check with a qualified electrician if you are not sure the range hood is properly grounded.
Ź
Do not have a fuse in the neutral or ground circuit.
Ź
This appliance requires a 120V 60Hz electrical supply and connected to an individual properly grounded branch circuit protected
by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire with ground. Please also refer to Electrical Diagram
on product.
Ź
A cable locking connector (not supplied) might also be required by local codes. Check with local requirements, purchase and
install appropriate connector if necessary.
* National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
Federal Communication Commission Interface Statement
Ź
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Ź
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
Ź
Reorient or relocate the receiving antenna.
Ź
Increase the separation between the equipment and receiver.
Ź
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Ź
Consult the dealer or an experienced radio/TV technician for help.
READ AND SAVE THESE INSTRUCTIONS
Summary of Contents for Milano
Page 2: ...2 Milano Use Care and Installation Guide MIL ANO WALL CORE...
Page 36: ...36 Milano Use Care and Installation Guide MIL ANO WALL CORE Notes...
Page 40: ...2 Milano Guide d utilisation d entretien et d installation MIL ANO MUR CORE...
Page 74: ...36 Milano Guide d utilisation d entretien et d installation MIL ANO MUR CORE Remarques...