Zephyr Milano, Use, Care And Installation Manual

Page: 15 / 76

15 Milano Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Installation Instructions
9. Hang hood onto the mounting screws and hand tighten each screw. (FIG. B1) Secure the third #6 x
1-1/2” screw through inside of hood into wall for extra support. (FIG. B2).
10. Center and attach duct cover mounting bracket to wall just below the ceiling or soffit using (2) #6
x 1” screws.
11. Install electrical and duct work. Seal duct work with aluminum duct tape. Re-install electrical
junction box with cable lock and install the electrical. (FIG. A2).
12. Unwrap the blue antenna wire and position it behind the duct cover from step 14. There is no need
to secure it.
13. Power up hood and check for leaks around duct tape.
14. Place telescopic duct covers onto hood and extend inner (top) duct cover upwards and secure to
duct cover bracket using (2) M3.5 x 8 screws.
15. Place canopy over hood body and secure it to hood body using (4) 3/16 x 1/4 screws through filter
opening. Hand tighten screws only.
16. Reinstall aluminum mesh filter.
NOTE:
If using hood in recirculating mode you must secure the air diverter plate onto wall before
installing duct work and duct covers. Turn to page 19 for more details.
Mounting the Hood