25
Lux Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Features & Controls
RF Remote Control
To order the RF remote control, the part number is 14000005. The blue antenna wire needs to be
extended for optimal signal. Unwrap the antenna wire and position it behind the duct cover. It does
not need to be secured.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Synchronization
To create a unique link between your hood and remote control please follow these steps.
1. With the hood and lights off, press and hold Light for on the hood for 3 seconds until the slowly
blinking indicators stop.
2. Press on the remote, and the remote control will be synchronized with the hood.
RF Remote Control Functions
Blower On / Speed Selection
Press to power on blower and cycle through all 3 blower speeds.
Blower On / Power Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Auto Delay Off
Lights 1/2/3/Off
Switch between light levels by pressing . Turn off the lights by cycling through
the different light levels.
Blower On/
Speed Selection
1
1
2
3
4
Blower On/
Power Off
2
10 Min Delay Off
3
Lights 1/2/3/Off
4
By pressing , the blower and lights will enter Automatic Delay Off mode. The
clock icon will illuminate and the controls will illuminate “Auto-Off”. The blower
will change to speed 1 and a 10 minute timer will begin counting down.
Additional Functions
1. + :Reset clean grease filter reminder
2. + :Reset replace charcoal filter reminder
3. + :Enable/disable clean air mode
4. + :Enable/disable Bluetooth® pairing mode
