Installa
tion - Ex
ternal & In-Line Blo
w
er P
repar
a
tion
NOTE! The device in this version
(with external motor) is equipped for
rear discharge of exhaust air. However,
if required, it is possible to have the
exhaust air discharged from the top.
This can be accomplished by carrying
out the steps indicated in the follow-
ing paragraphs; upon reaching step 7,
the motor plate must be rotated and
installed in the opposite direction.
The following instructions are for preparing the hood for use with an ex-
ternal or in-line blowers models CBE-1000 or PBN-1000A.
CAUTION: To reduce the risk of fi re and electric shock, install this rangehood
only with remote blowers rated maximum 6.2 A.
For internal blower instructions please turn to page 10.
1. Open the front panel. Fig.1
NOTE!
Open the front panel while holding
it by its external sides, as shown in Fig.1 ,
and keep at a suitable distance to avoid
impacting it.
2. Remove the Decorative Mesh Filters.
3. Loosen the two screws inside the hood
that fasten the canopy. Fig.2
4. Slide the top cover off by lifting it. Fig.3
- 13 -
