5. Replace the 6 wing nuts,
tightening only the two at the
front and leaving the other 4
loose. Fig.4
6. Close the door carefully un-
til it latches.
- Check for correct alignment:
the side edges have to be aligned, and the distance between the top se-
cured glass and the lower glass should be approximately 1/16” across the
whole width. Fig. 5
- If the glass is po-
sitioned correctly
you may continue
to step 9, otherwise
please continue to
the next stage.
7. Open the door
again, then loosen
the 2 front wing
nuts and adjust the
alignment by sli-
ding the glass.
8. Tighten the 2 front wing nuts and try closing the door again.
Please Note!
If the alignment is still not correct, repeat the procedure
from step 7.
9. Open the door and tighten the 4 remaining nuts.
Now the glass has been fully secured to the hood.
min 1/16"
Installa
tion instruc
tions
- 3 -
