GZ4000
GB-14
side of a cutter. If a gap is observed between them,
the rail is normal. Otherwise, the bar rail is worn.
Such a bar needs to be corrected or replaced.
9. Troubleshooting Guide
Case 1. Starting failure
Make sure the icing prevention system is not
working.
Check fuel for water
or substandard mix-
ture.
Replace with proper
fuel.
Check for engine
flooding.
Check spark ignition.
Remove and dry the
spark plug.
Then pull the starter
again with no choke.
Replace with a new
plug.
Case 2. Lack of power/Poor acceleration/
Rough idling
Case 3. Oil does not come out
Check fuel for water
or substandard mix-
ture.
Check air filter and
fuel filter for clog-
ging.
Check carburetor
for inadequate ad-
justment.
If the unit seems to need further service, please consult
with an authorized service shop in your area.
Replace with proper
fuel.
Clean.
Readjust speed
needles.
Check oil for sub-
standard quality.
Check oil passage
and ports for clog-
ging.
Replace.
Clean.
a
d
d
a
a
d
d
a
a
a
d
a
a
Be sure to round off the front edge to reduce
the chance of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as illustrated.
■
Guide Bar
•
Reverse the bar occasionally to prevent partial wear.
•
The bar rail should always be square. Check for wear
of the bar rail. Apply a ruler to the bar and the out-
Cutter length
Filing angle
Side plate angle
Top plate cutting angle
Ruler
Gap
No gap
Chain tilts
WARNING:
This saw is equipped with one of the following low kick-
back bar/chain combinations:
Zenoah Part Number
Bar Size
Guide Bar
Saw Chain
14
848CB44C11
848CC95V60
16
2939-52111
2939-52210
10. Disposal
•
When you dispose of the machine, do not disas-
semble the machine.
•
When you dispose of the machine, fuel, chain oil,
be sure to follow your local regulations.
