GB-11
G
B
EX2600
MOUNTING ENGINE
1. Push the shaft tube toward the clutch housing and
rotate it by hand to check that the power transmission
shaft is engaged with the gears.
2. Insert the power transmission shaft into the clutch
housing until it bottoms, and align the positioning holes
on the clutch housing and the shaft tube and install
the screw. When difficult to engage, twist the engine
slightly.
3. Fasten the clamp securely with two screws.
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
Insert the cable
to the end of
adjuster
Full on stopper
Adjuster
idle speed adjuster
1. Connect throttle wire with carburetor. Insert the cable
to the end of adjuster.
2. Make sure the ‘STOPPER-PLATE’ of carburetor moves
to contact with ‘IDLE SPEED ADJUSTER’ and the
‘SWING-ARM’ of carburetor moves to contact with
‘FULL ON STOPPER’ by gripping throttle lever.
CONNECTING SWITCH WIRES
• Connect the switch wires between the engine and the
main unit. Pair the wires of the same color.
SUSPENSION POINT
NOTE
Be the SUSPENSION POINT
in the location of the arrow
mark.
INSTALLING HANDLE
(BC-EX3, LRT-EX only)
NOTE
The handle is put during the arrow mark.
About 19 inches (48cm)
MIN
SPACIN
G
• Mount the handle to the shaft tube and suspension point
it at a location that is comfortable to you.
(PS-EX2 only)
• Insert the grip to the shaft tube.
• Fasten the clamps with screws.
JOINT ATTACHMENT
Knob bolt
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely.
6. Set up
arrow mark
SUSPENSION
POINT
01-EX2600_GB_cs5_二.indd 11
17/04/14 18:09
