BCZ5050DW
12
9. Maintenance
8. Use
• Choose a suitable recommended cutting attachment
according to the object to be cut. Never use other
cutting attachment not approved by Husqvarna
Zenoah.
When using a metal blade:
1. Check the bolt to fasten the blade and be sure the
bolt has on fault, and no abrasion.
2. Be sure that the blade and the holder have been
fastened according to instruction and the blade turns
smoothly without abnormal noise. The rotating parts
fastened incorrectly may cause serious accident to
the operator.
3. Cutting method:
a) Use the front left side for cutting.
b) Guide the blade from your right to left with it tilted
slightly to your left.
c) When mowing a wide area, start working from
your left end to avoid interference of cut grass.
d) The blade may be seized by weeds if the engine
speed is too low, or the blade cuts too, deep into
weeds. Adjust the engine speed and cutting depth
according to the condition of object.
For your health and to prevent the risk from
vibration, refrairr from working for a long time at
the cold temperature.
WARNING
Before cleaning, inspecting, or repairing the unit,
make sure that the engine has stopped and is cool.
■
REFILLING TRIMMING LINE
For safety reasons, do not use metalreinforced line.
1. For replacement line, use a diameter of .095 in (2.4
mm). The cord holder is capable for a line up to 20 feet
(6 m) on the 4” head. Avoid using a larger line as it may
cut down the trimmer performance.
2. Pinch the slotted area on the both sides of the case to
unhook the cover.
3. Take out the cord holder and pull off the old line. Fold
new line so that one half line is 4.7 in. (12 cm) shorter
than another half. And then, hook bended end in the
slot of the cord holder.
4. Wind up the line in the correct direction as indicated on
the spool.
5. Hook each end of the line in the slot on the edge of the
cord holder.
6. While holding the cord holder against the cover, pull the
line ends to release them from the slot, and then put the
ends through the eyelets on the cover.
7. Line up the slot on the cover with the hook on the case.
Make sure the spring is in place on the case.
Press the cover against the case until it clicks.
WARNING
