Zenoah BCZ260L, Operator'S Manual

Page: 15 / 200

engine temperature, which can result in
serious engine damage.
CAUTION: If your product is equipped with a
catalytic converter use a good quality
unleaded gasoline/oil mixture. Leaded
gasoline will destroy the catalytic converter.
• Use low-emission gasoline, also know as alkylate
gasoline, if it is available.
• Ethanol blended fuel, E10 may be used (max 10%
ethanol blend). Using ethanol blends higher than
E10 will cause lean running condition which can
damage the engine.
• We recommend a higher octane rating when you do
work at continuous high speed.
Two-stroke oil
• For best results and performance use Zenoah two-
stroke oil, which is specially formulated for our two-
stroke engines.
• If Zenoah two-stroke oil is not available, you may
use another two-stroke oil of good quality that is
intended for air cooled engines.Contact your dealer
when you select an oil.
• Do not use two-stroke oil intended for water-cooled
outboard engines, also referred to as outboard oil.
• Do not use oil intended for four-stroke engines.
Gasoline, litre Two-stroke oil, litre
2% (1:50)
5 0,10
10 0,20
15 0,30
20 0,40
To make the fuel mixture
Note: Always use a clean fuel container when you do
the fuel/oil mixture. Do not make more than a month
quantity of fuel mixture. Empty and clean the fuel tank
before long storage.
1. Add half of the gasoline quantity. Add the full
quantity of oil.
2. Shake the fuel mixture.
3. Add the remaining gasoline quantity.
4. Shake the fuel mixture.
5. Fill the tank.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed. Use a fuel container with an anti-spill
valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and source before starting.
CAUTION: Contamination in the tanks
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
• Make sure that there are no cracks at the bottom,
teeth or the center hole of the blade. Cracks most
usually occurs because sharp corners are shaped at
the bottom of the teeth while you sharpen the
353 - 003 - 06.01.2018 15