Technical Support:
5
INSTALLATION
Figure 1 shows the connection outilne of the device:
Figure 1.
Schematic diagram.
Flat Display v2 is connected to the KNX bus through the built-in terminal (2). An external
DC power supply is not needed.
A short press on the
Prog./Test button
(4) will make the device enter the programming
mode. The
Prog./Test LED
(3) will light in red. On the contrary, if this button is held while
plugging the device into the KNX bus, the device will enter the
Safe Mode
. In such case,
the programming LED will then blink in red.
For detailed information about the technical features of Flat Display v2, as well as on
security and installation procedures, please refer to the
Datasheet
, bundled within the
device packaging of also available at
1.
Temperature and Humidity Sensor.
2.
KNX connector
3.
Prog./Test LED.
4.
Prog./Test Button.
5.
Attachment Clips.
6.
Inputs Connector.
7.
Display.
8.
Touch Area.
9.
Luminosity and Proximity Sensor.
3
2
7
5
4
6
1
8 9
Ref. ZAC-HOLD (included)