Zennio ZoningBOX 6, User Manual

Page: 29 / 44

ZoningBOX 6 / ZoningBOX 4
http://www.zennio.com Technical Support: http://support.zennio.com
29
•
Fan Speed [ No Change / Minimum / Intermediate / Maximum ]: fan
speed level to be set on the execution of the scene (the actual options
will depend on the fan configuration; see section 2.2.4).
2.2.7 RESET
The Reset function allows sending certain objects (either status writings or status
requests) to the KNX bus after a bus failure or a download from ETS.
Sending the grille control objects : this option is intended to let ZoningBOX
send the corresponding grille control objects after a reset:
➢
[Group n] [Gy] [Control] Grille Control.
Sending the status objects of the HVAC unit : this option is intended to let
ZoningBOX send the interface of the HVAC unit the last known status. To that
end, the following status objects are sent to the KNX bus are:
➢
[Unit x] On/Off HVAC Unit.
➢
[Unit x] Global Temperature Setpoint.
➢
[Unit x] Mode (Status)
➢
[Unit x] Heat Mode (Status)
➢
[Unit x] Cool Mode (Status)
➢
[Unit x] Fan Mode (Status)
➢
[Unit x] Dry Mode (Status)
➢
[Unit x] Simplified Mode (Status)
➢
[Unit x] Fan: Speed Percentage (Status)
➢
[Unit x] Fan: Speed Enumeration (Status)
➢
[Unit x] Fan: Speed Minimum (Status)
➢
[Unit x] Fan: Speed Intermediate (Status)
➢
[Unit x] Fan: Speed Maximum (Status)
Sending status requests : this option is intended to let ZoningBOX learn the
status of the installation during the start-up. To that end, ZoningBOX sends
reading requests through the following objects:
➢
[Group n] [Zi] Enable/Disable Zone.
➢
[Group n] [Zi] Setpoint Temperature.
➢
[Group n] [Zi] Reference Temperature.
➢
[Group n] [Zi] Control Signal from Thermost.
➢
[Group n] [Gi] [Control] Grille Status.
➢
[Unit x] Setpoint Limits
➢
[Unit x] Minimum (Cool Mode)
➢
[Unit x] Maximum (Heat Mode)
➢
[Unit x] Return Temperature
➢
[Unit x] Mode
➢
[Unit x] Heat Mode
➢
[Unit x] Cool Mode
➢
[Unit x] Fan Mode
➢
[Unit x] Dry Mode
➢
[Unit x] Simplified Mode.
➢
[Unit x] Fan: Speed Percentage (Status)
➢
[Unit x] Fan: Speed Enumeration (Status)
➢
[Unit x] Fan: Speed Minimum (Status)
➢
[Unit x] Fan: Speed Intermediate (Status)
➢
[Unit x] Fan: Speed Maximum (Status)
➢
[Unit x] On/Off HVAC Unit (Status)