ZPS160MPA
160 mA Power Supply
ZN1PS-160MPA
Technical Documentation
© Zennio Avance y Tecnología S.L. Edition 4 Further information
Page
2/2
GENERAL SYSTEM SPECIFICATIONS
CONCEPT
DESCRIPTION
Device type
Electric operating control device
External power supply
Voltage
230 VAC, 50/60 Hz
Consumption
Max. 100mA
KNX output
Voltage
29 VDC SELV
Output (I
BUS
)
Max. 160mA
Additional output
Voltage
29 VDC SELV
Output (I
AUX
)
I
AUX
+ I
BUS
≤ 250mA
Operation temperature
from -5ºC to +45ºC
Storage temperature
from -20ºC to +55ºC
Operation humidity
from 30 to 85% RH (no condensation)
Storage humidity
from 30 to 85% RH (no condensation)
Complementary characteristics
Class B
Protection class
Class I
Operation type
Continuous operation
Device Action type
Type 1
Electrical stress period
Long
Installation
Independent to be mounted inside distribution boxes or electrical
panels.
Minimum clearances
---
Power failure back-up time
200ms
Max current before overload
350mA
Protection fuse
Voltage
250V AC ~ 50 Hz
Current
2.5 A
Response
Type F (fast response)
Connection type
Three screw terminals clamp
Cable section
from 0.5mm² to 2.5mm²
Cable type
Flexible cable with crimping terminals or rigid cable without
terminals
Operation indicator
Green LED ON implies a correct bus voltage
Weight
200g
PCB CTI index
175V
Housing material
PC+ABS FR V0 Halogen free
SAFETY INSTRUCTIONS
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country.
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for the
entire KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the
wires of other accessories, in case of being installed.
The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini-circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
The device has a short-circuit protection fuse that, in case of activation, should only be rearmed or replaced by the Zennio
technical service.
Once the device is installed (in the panel or box), it must not be accessible from outside.
Keep the device away from water and do not cover it with clothes, paper or any other material while in use.
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructions
