Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
123
Example II: suppose a certain CO
2
sensor responsible for sending the value
“0” to the
bus every two minutes, except when it detects a dangerous CO
2
level; in such case, it
will immediately send the value
“1”. If the object being sent is linked to the alarm trigger
object from an alarm box in Z41 Pro / Lite / COM where periodic monitoring has been
parameterised and where the value
“1” is configured as the alarm trigger value, then Z41
Pro / Lite / COM will notify the user about the emergency both if the CO
2
level reaches a
dangerous level and if the sensor stops sending the value
“0”, for example due to failures
or sabotage. The user should proceed in the same manner as in the above example to
manage the alarm notification
.
3.6.2.5.8
Holiday Calendar
Figure 123
Holiday Calendar
Boxes configured as a Holiday Calendar let the end user set a number of holidays on a
calendar, and to program the sending of one value or another when the date changes,
depending on whether the new date is a weekday or not.
It is necessary to configure the following parameters:
Send 1-bit Object
: always-enabled parameter to make it evident that on a date
change, the device will always send a 1-bit object to indicate whether the new
day is a weekday or a holiday.
Value
: values that will be sent through the 1-bit object depending on whether the
day is a weekday or a holiday. Options: “0 = Weekday; 1 = Holiday” (default
option) and “1 = Weekday; 0 = Holiday”.
