MAXinBOX 24
http://www.zennio.com
Technical Support:
http://support.zennio.com
5
1.2
INSTALLATION
MAXinBOX 24 connects to the KNX bus through the on-board KNX connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application programme may be downloaded.
This device does not need any additional external power since it is entirely powered
through the KNX bus.
Figure 1.
Element Diagram for MAXinBOX 24.
The main elements of the device are described next.
Prog./Test Pushbutton (5)
: a short press on this button sets the device into
the programming mode, making the associated LED (6) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. In such case, the LED will blink in red every
0.5 seconds.
Outputs (1 and 2)
: output ports for the insertion of the stripped cables of the
systems being controlled by the actuator (see section 2.2). Please secure the
connection by means of the on-board screws.
To get detailed information about the technical features of this device, as well as on the
installation and security procedures, please refer to the corresponding
Datasheet
,
bundled with the original device packaging and also available at
www.zennio.com
.
1.
Outputs.
2.
Output status LED.
3.
Manual Control Pushbutton
4.
Fixing clamp.
5.
Prog./Test LED Pushbutton.
6.
Prog./Test LED Indicator.
7.
KNX Bus Connector.
1
2
3
4
5
6
7
