LUMENTO X4
LED DIMMING
RGB CONTROLLER
ZN1DI-RGBX4
Technical Documentation
© Zennio Avance y Tecnología S.L. Edition 3 For further information
www.zennio.com
Page.
2
of
2
WIRING AND ASSEMBLY DIAGRAMS
Recommended installation:
NOT recommended:
Vertical position.
If there is not any
other possibility,
install terminal block
up (see fig.)
SAFETY INSTRUCTIONS
Do not connect mains voltage (230V) or any other external voltages to any point of the bus. Connecting an external voltage
might put the entire KNX system at risk.
Make sure during the installation that there is always sufficient insulation between the mains voltage 230V and the bus or the
extension inputs.
When overheating protection is active, the device will decrease the luminosity level (50%) and control frequency. For further
information, please read the user manual.
The voltage of the power supply connected to LUMENTO will never exceed the voltage required for the load, which is specified
by the manufacturer. Not following this recommendation would mean a risk for the installation.
OUTPUT SPECIFICATIONS AND CONNECTIONS
Maximum current per channel
2.5A @ 25ºC ambient temperature
Number of channels
4
Total power connected
120W (12V DC) or 240W (24V DC)
Connection type
Terminal block (screw)
Cable section
1.5 mm² to 2.5 mm²
Load type
Common anode
Shortcut protection
Yes
Overheating protection
Yes
LED
The LED load is connected to the terminal block, matching the anode or the anode common
terminal of the LED stripes with C (anode). The cathode can be connected to several output
channels if it is necessary more than 2.5A (up to 10A) for the LED strip,
as long as the length
and section of the wires used for the connections between the outputs and the strip are
the same.
Correspondence
C
: Anode
1
: Red
2
: Green
3
: Blue
4
: White
Assembly:
Screw mounting, 2 holes of
3.5 mm diameter. Screws
not included.
External power supply:
+ and - terminals of
external power supply 12
or 24 VDC
