Zenith Z-170, Owner'S Manual

Page: 23 / 147

17
Operation
To "load" the disk operating system, take the MS-DOS Distribution Disk
I and insert it into drive A as follows:
Press the middle of the drive door. The spring-loaded door will pop
open.
Insert the disk into drive A with the label side at the end, facing
you, as shown. Slide the disk all the way in until it latches into place.
If the disk does not slide into the drive easily, check the label on
the disk. Make sure it's not interferring.
After you've "loaded" the MS-DOS disk:
Carefully close the door. Make sure it snaps shut. This engages the!
drive hub into the disk so the drive can operate.
Press the Disk Icon (see page 23).
You should see the following message on the screen:
Booting ...
MS-DOS version 2.XX
Copyright 1981, 82, 83, 84 Microsoft Corp.
Current date is XX:XX:19XX
Enter new date:
Current time is: XX: XX: XX
Enter new time: