595-5507-10
-2-
2.
Set the push button jumpers to match the chime receiver
code. See "Code and Tune Setting" section.
1.
Install alkaline type A23 12 volt push
button battery. Remove back of case
by pushing in tab on bottom with a small
screwdriver. Make sure battery is ori-
ented properly (see page 5).
4.
Mount push button.
Use either screws or double sided tape
to mount push button.
To mount with screws, remove back of
case by pushing in tab on bottom with a
small screwdriver.
Attach back of case to door jamb or wall.
Snap front of push button on.
When attaching push button using double sided tape, make sure
the surface of the door jamb or wall is clean.
3.
Test range. Temporarily position push button where you want
it mounted. Press push button to verify chime and push button
work properly. If chime does not sound, see Troubleshooting.
