Zenith R40W46 Series, Service Manual

Page: 9 / 61

- 9 -
PROGRAMMING CODES
Programming the Remote
The remote control for your HD receiver is a multi-brand or universal
remote control. It can be programmed to operate most remote-
controllable devices of other manufacturers.
Note that the remote control may not control all models of other
brands.
1. Test your remote control.
To find out whether your remote control can operate the
component without programming, turn on the component such as
a VCR and press the corresponding mode button (VCR) on the
remote control, while pointing at the component. Test the POWER
and CH +/- buttons to see if the component responds properly. If
not, the remote requires programming to operate the device.
2. Turn on the component to be programmed, then press the
corresponding mode button on the remote control.
3. Press the POWER and MUTE buttons simultaneously, the remote
control is ready to be programmed for the code.
4. There are two ways to find the right code for the component.
A. If you press the CH +/- buttons repeatedly, the codes will
change one at-a-time. Press the POWER button after each code
change. If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the remote.
Programming code numbers for the corresponding component
can be found on the following pages. Again, if the code is correct,
the device will turn off.
5. Press the EXIT button to store the code.
6. Test the remote control functions to see if the component
responds properly. If not, repeat from step 2.
1 2 3
4 5 6
7 8 9
0
tv vcr cable dvd sat
mode light power
tv/video sleep comp/dvi
flashbk cc arc
video audio
fcr mute
vol ch
swap pipch- pipch+ pip
still pip input position mts
menu exit
record stop pause
rew
play
ff
skip
right
enter
left
down
up
3/4
3
4
5
2
4
All manuals and user guides at all-guides.com