22
Quick Start Installation Guide
806836NZ v1.02 02.22 G5 B BA Quick Start Guide
SECTION 12: Commissioning
Tank flush
(does not apply to chilled sparkling models)
• Follow the instructions to flush the tanks.
Dispense water from the tap if instructed.
• Note
The ‘Auto Dispense’ option will be
enabled/disabled based on the selection
made in the drain away option screen.
It can be altered by touching the toggle
button.
• Note
Care should be taken if enabling
‘Auto Dispense’ if the tap drains over a font
as it may overfill during the tank flush.
• Make a selection and press Run to start
the tank flush.
• If ‘Auto Dispense’ is enabled the tanks will
fill and empty automatically except if the
water in the hot tank is above 50°C. In this
case follow the prompts on the screen
to utilise the tap and its safety feature to
empty the hot tank.
• If ‘Auto Dispense’ is disabled the tanks will
fill automatically. When prompted use the
tap to dispense water and empty the tanks.
If the hot tank has water above 50°C then
use the taps safety feature to dispense.
B, BA Models
12:12 PM
TANK FLUSH
Fresh water will be flushed through the
tank/s multiple times as shown by the cycle counter/s.
Enabling ‘Auto Dispense’fill/empty
the tank/s automatically.
Toggle to manually dispense from the tap.
If prompted dispense water from the hot tank
using the taps safety feature.
12:12 PM
BOILING CALIBRATION
88.0
°C
80.0
°C
Boiling Water Temp.
Steam Vent Temp.
0
Element Power %
Water tank is filing
Safety
Hot
Boiling calibration
• Press the green button and the system will
start the boiling calibration procedure.
This can take up to 10 minutes.
12:12 PM
TANK FLUSH
Hot Tank
Cycle 1/2
98.0 °C
Run:
Auto
Dispense