Page 22 of 28
802253NZ - HT BC Residential Instructions 10.18 v3.00
•
Turn ON the water and check for any leaks.
•
Turn the power ON at the power outlet and at the side of the undersink unit
•
If fitted, ensure the Booster is turned OFF (Booster is commissioned, later, at section 5.4)
•
Familiarise yourself with the operation of the Tap, in preparation for use (See User Guide)
•
Follow the Installation instructions below (and review Section C of the User Guide).
•
After commissioning, the system may be customised by selecting further options in Section G -
Settings, within the User Guide.
1. Turn the stop cock ON
2. Press [Start] [Stop] buttons to start and stop the filter flush.
3. Allow at least 10 litres of water to flush through the filter.
4. Once the filter flush is finished, Turn the stop cock OFF
then press [Stop] to end filter flush mode.
Have a 10L bucket or similar container (not supplied) at the
ready to hold a quantity of water that will be ejected while the
Filter Flush Mode is in operation. Open the filter access door
on the front of the HydroTap and the filter cartridge will be
exposed. Located to the rear RHS of the cartridge is a flush
line and the flush line stop cock. Place the valve end of the
flush line into the 10L bucket or container (not supplied).
5.2
-
Filter Flush
Section 5
Commissioning
NOTE:
For any subsequent filter changes or any operational
procedures, please refer to the HydroTap user guide, located
inside the filter housing access door.
5.1
-
Select the Language
Initial Commissioning screen
Language selection screen
OPEN
CLOSED
Stop cock
operation
