Page 18 of 36
802253NZ - HydroTap BC, BCHA-AV, AIO, Installation Instructions - Aug 2015 - V2.01
Cut a 50mm hole in the bench / sink top.
SINK TOP
1.14
50mm
Note
: make sure the tap location will allow the
nozzle to drain into the sink. (See Page 11)
All-In-One Tap
Installation
Min 300mm
335mm
470mm
1.15
•
Fit the seal ring to the base of the tap and If mounting on an uneven surface, apply a light smear of
silicone sealant to ensure a watertight seal
•
Mount the tap on top of the cut out hole after passing the usb cable and tubes through the 50mm hole
•
Thread the cable and silicon tubes through the circular clamp block (Check the tube colour alignment
with the coloured dots on the clamp block). (See fig.1.16)
•
Clamp the assembly in position using the threaded nut and clamp block
•
Working from inside the cupboard, attach the braided hoses to the tube extensions (ensure the seals
on the end of the hoses are lubricated). Check the correct position for Hot and Cold connections by
matching the colours on the braided hoses with the coloured markings on the copper extension tubes.
(See fig 1.18)
•
Test for leaks after all the connections have been secured.
Installation Procedure
