Zenith GlobalPlus 800955NZ, Installation Instructions Manual

Page: 4 / 12

Page 4
Read These Warnings First
• Ensure that the location and fasteners will support the weight of the system when in-
stalled and full of water.
• Ensure all tubing and fi ttings are secure and free of leaks.
• Do not install using rigid piping. System intended for use with plastic water lines (such as
PEX tubing, PE tubing, PP tubing).
• The disposable fi lter cartridge MUST be replaced every 12 months, at the rated capacity or
sooner if a noticeable reduction in fl ow rate occurs.
How to Replace the External Filter Cartridge
This instruction is for the replacement of the filter in product where the filter is mounted
externally. In preparation for your filter activation/flushing, ensure you have a 10 litre
container available.
Some water may drip from the filter head (socket) during replacement. Keep a towel handy to
dry up any drips.
To Change the Filter:
1. Shut off the main water supply isolation valve at the wall.
2. Grasp filter cartridge and twist right to left one quarter turn until it stops.
3. Ease cartridge downwards to detach it from the filter head (socket).
Caution: A small amount of water will drip as the cartridge is removed.
4. Do not tilt the cartridge as water may spill from it.
5. Unpack the replacement cartridge, remove the sanitary cap and write today’s date where
shown on the label.
6. Avoid touching the filter “O” rings and filter opening as this may cause bacterial
contamination of the cartridge.
7. Align the filter cartridge marker IN/OUT with the marker on the left side of the filter head.
8. Slide the cartridge upward into the head and rotate from left to right until the LOCK
marker aligns with the filter head marker.
9. Re-open the main water supply isolation valve at the wall.
10. To activate the cartridge, if connected to a filter tap, run water by opening the tap until
approximately 10 litres of water has passed through the filter. (for other combined
products see warning below)
11. Wipe up any spills and dispose of the spent filter cartridge and packaging thoughtfully.
Warning:
If the filter is external to a boiling water, chilled water or combined boiling and
chilled water dispensing product, the hose that enters the dispensing product should be
disconnected from the product and the filter activation/flush needs to be directed through this
hose into a bucket to avoid flushed particles from entering into the storage tanks.
1
2
REMOVE FILTER
INSERT FILTER
FILTER CARTRIDGE REPLACEMENT
How to Replace the Internal Filter Cartridge
2
1
This instruction is for the replacement of the filter in the Zenith HydroTap product where
the filter is mounted internally. In preparation for your filter flushing, ensure you have a 10 litre
container available.
Some water may drip from the filter head (socket) during replacement. Keep a towel handy to
dry up any drips.