206-3489-O
P A G E 8
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
Hook Up an Off-Air Antenna
Connect an off-air antenna
If you have a 75 ohm RF cable, then you
don’t need any adapters!
A 300 to 75 ohm adapter is not included with
the TV.
300 TO 75 OHM
ADAPTER
Typical
TV Back
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
ANTENNA
CABLE
RF Coaxial Wire
(75 ohm)
Antenna
Typical
TV Back
ANTENNA
CABLE
Locate the Antenna/Cable jack on the back of
your Entertainment Machine.
Connect the wire that runs from the wall
directly to this jack, according to one of the
diagrams to the right.
Remove the back of the remote and put in two
“AA” batteries.
Plug in your TV. Do not plug it into an outlet
controlled by a switch. Your Entertainment
Machine is designed to operate on standard
household current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
Back of
Remote
1
2
3
4
