Locate the Antenna/Cable jack on the back of the TV.
Connect the antenna wire that runs from the wall
directly to this jack, according to one of the diagrams
to the right.
Remove the back of the remote and put in two AA
batteries.
Plug in the TV. Do not plug it into a switched outlet.
The TV is designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to operate it
on DC power.
Go to page 12 to Auto Program the TV.
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
206-3489-O
P A G E 7
Hook Up Your Antenna to the TV
300 TO 75 OHM
ADAPTER
TV Back
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV Back Connections Panel
(Expanded View)
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
ANTENNA
CABLE
M.P.I.
TV Back
TV Back Connections Panel
(Expanded View)
RF Coaxial Wire
(75 ohm)
Antenna
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
ANTENNA
CABLE
M.P.I.
Back of
Remote
120 V AC
60 Hz
1
2
3
4
5
Connect an off-air antenna to the TV
If you have a 75 ohm RF cable, then you don’t need
any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith TV.
Summary of Contents for Concierge H27E35DT
Page 43: ...P A G E 4 3 206 3489 O Notes ...
