Zenith Concierge H20C35DT, Installation And Operating Manual, Warranty

Page: 10 / 48

P A G E 1 0
206-3489-O
Hook Up Cable Service (CATV) and VCR
Connect a VCR and Cable service to the TV
Leave the VCR and the television tuned to channel
three and use the cable box to change channels.
No A/V cables are included with your TV. Without
A/V cables, most VCRs will not play videocassettes
in stereo sound.
Cable TV
wall jack
Round wire (75 ohm)
Cable box
In
Out
3 4
output
switch
A/V cables
not included
with TV
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
In
Out
Audio Video
3 4
VCR back
VCR back AV panel
output
switch
ANTENNA
CABLE
M.P.I.
TV back panel
(expanded view)
TV back
Cable TV
wall jack
Round wire (75 ohm)
A/V cables
not included
with TV
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
In
Out
Audio Video
3 4
VCR back
VCR back AV panel
output
switch
ANTENNA
CABLE
M.P.I.
TV back panel
(expanded view)
TV back
Locate the Antenna/Cable jack on the back
of the VCR.
Connect the cable that runs from the wall
directly to this jack, according to the dia-
gram to the right. As required, make the
other connections as shown to the right.
Remove the back of the remote, put in two
AA batteries.
Plug in the TV. Do not plug it into a
switched outlet. The TV is designed to oper-
ate on standard current, 120-volt 60 Hertz
AC. Do not attempt to operate it on DC
Current.
Go to page 12 to Auto Program the TV.
back of
remote
1
2
3
4
5