CM151
1-10
CA - 1384 MENUS
USER MENUS 221-1384
SETUP MENU
The
Setup
Menu
for CA chassis with its options for each
item are described as follows:
AUTO PROGRAM
The Auto Program feature automatically searches for all
available channels and marks them as
Added
so that they
may be accessed via the channel Up/Down key.
In the Auto Program screen:
· A message at the top displays “Auto Program” to let
the customer know that they have entered the Auto
Program feature.
· A line at the bottom of the screen shows that the Up/
Down and Left/Right Arrow keys are used for Auto
Program selections.
· The current RF input type (Off Air Antenna or Cable
TV) is highlighted. Use the Up/Down Arrow keys to
change the RF input type.
To start the Auto Program, press the Left/Right Arrow
key. If the Cable TV input type is selected, the Auto
Program routine will determine what type of cable system
is present.
Notes:
•
Auto program clears all Surfing channels which were
added.
•
While searching for channels, all keys except for
the Power key are disabled. This prevents an
incomplete Auto Program procedure.
•
Running the Auto Program will clear the factory
mode, if it was active. This happens at the end of
the Auto Program.
•
If the Auto Program line in the Setup Menu is ‘red’,
this indicates that the module did not pass one of
the test equipment’s tests.
•
If no channels are found then the following message
will appear: “Make sure that the cable/ant. is
connected , and try again.”
CHANNEL/ADD/DEL
After running the Auto Program, all channels found by
the Auto Program feature will be marked
Added
. However,
some of these channels may be scrambled, or undesired
by the customer. This feature allows the customer to
selectively mark any channel as
Deleted
or
Added
.
To change the status of a channel from
Added
to
Deleted
or vice versa, press the Left/Right Arrow key.
To change the channel while adding or deleting channels,
use the Channel Up/Down keys, or press the desired
channel digits, followed by ‘Enter’. If Channel Up/Down
is pressed, the next or previous channel which was marked
Added
will appear. If only one channel is present, to
change the channel the customer must use the digit key
pad to select a channel.
CLOCK SET
This Setup Menu Line allows the customer to set the
clock time and date.
When no time is set, the display shows:
—:—
—
There are two ways to set the time:
1. Direct Entry (preferred) Use the digit keys, followed
by ‘Enter’ or Select Up/Down.
2. Left/Right Arrow keys
When the first digit is introduced, the display shows:
—:-d AM
< Timer
When the time is set, the display shows:
hh:mm
AM
< Timer
where
:
d = digit, mm = minutes hh = hours
Entering an invalid time (“0” for example) will result in
the clearing of the current time (—:— —). Also when
only one digit is pressed and no other is pressed in an
interval of seven seconds, the current time will be cleared.
Note: When the first digit is pressed (or the Left/Right
Arrow is pressed), a TIMER icon appears on the
right side of the AM/PM status.
TIMER MENU
The Timer Setup line allows entry into the Timer Menu.
This feature consists of three menu lines: “On Time”,
“Off Time”, and “On/Off Timer”. This feature allows the
set to turn on and off at the times specified in “On Time”
and “Off Time”. The “On/Off Timer” turns the feature on
and off. Setting the “On Time” or the “Off Time” is
identical to the Clock Set feature in the Setup Menu.
USER MENUS 221-1384
To Program
Setup Menu
Setup Menu
Ch. Add/Del
Clock Set
Timer Setup
Advanced TV Ctrl
Caption/Text
Audio Mode
Language