802006NZ - HT-BCS;BCSH A-AV User Manual - May 2016- v3.00
Page 23 of 32
3.
LCD Screen operation - Section G
This mode allows the HydroTap to enter into Energy Saving mode. There are
two options available: ‘Sleep’ mode and ‘ON/OFF’ mode.
To activate the sleep mode:
1. Press [MENU] button for main
menu.
2. Press [Setting] button.
3. Press [Energy Modes] button.
4. Press [Sleep Modes] button then in
the next screen, use the up and down
arrows to select one of the 7 options, as
shown in the table below.
Energy Modes
In Sleep Mode
the unit will go to “Sleep” after a 2hr period of inactivity.
The Boiling water will gradually drop to either 68°C or room temp, as shown
in the table below and the Chilled water will be ON or OFF.
When the period of inactivity passes, the home screen status window will
show “Sleep Mode”.
Lux (Light) Sensor Calibration:
(Not for Elite tap)
It is recommended to recalibrate the Lux (Light) Sensor after selecting any of
the 4 Lux sensor options from the sleep mode menu. Before commencing,
ensure there are ‘Normal to Dim’ (Not Dark) operating light conditions.
Note:
Refer to section C6 on Page 16 for calibration procedure
Sleep Mode
Light
Level
Time
Delay
State
Boiler
Chiller
2 Hours-> 68°C
N/A
2 Hr
Sleep
68°C
ON
2 Hours-> OFF
N/A
2 Hr
OFF
OFF
OFF
Lux Sensor->68°C
Dark
N/A
Sleep
68°C
ON
Lux Sensor-> OFF
Dark
N/A
OFF
OFF
OFF
Lux or 2 Hr-> 68°C
Dark
2 Hr
Sleep
68°C
ON
Lux or 2 Hr-> OFF
Dark
2 Hr
OFF
OFF
OFF
Disable
N/A
N/A
ON
ON
ON
