6
(1) Loosen the base bolt allen wrench attached
on base.
(2) Move the base fully forward, and tighten the
base bolt again.
(3) Attach the guide by passing it through the
attachment hole on the base and tighten the M5
bolt.
(4) Set the orbital position to “0”.
2. Cutting a circle or a circular arc
The guide also will be helpful for circular
cutting. After attaching the guide by same way
noted as above, drive the nail or screw into the
material through the hole on the guide, then use
it for a axis when cutting.
NOTE
Circular cutting must be done with the blade
approximately vertical to the bottom surface of
the base.
4. Cutting metallic materials
(1) Adjust the speed Dial between scales “3”
and “4”.
(2) Set the orbital position to “0” or “I”.
(3) Always use an appropriate cutting fluid
(spindle oil, soapy water, etc.). When a liquid
cutting fluid is not avaiable, apply grease to the
back surface of the material to be cut.
5. Pocket cutting
(1) In lumber
Aligning the blade direction with the grain of
the wood, cut step by step until a window hole
is cut in the center of the lumber.
(2) In other materials
When cutting a window hole in materials other
than lumber, initially bore a hole with a drill or
similar tool from which to start cutting.
6. Angular cutting
The base can be swiveled to both sides by up to
45° for angular cutting.
(1) Loosen the base bolt by allen wrench attached
on base and move the base fully forward.
(2) Align the scale (from 0 degrees to 45 degrees
by 15-degree increments) of the semi-circular
part of the base with the [ ] mark on the gear
cover.
(3) Tighten the M5 bolt again.
(4) Set the orbital position to “0”.
NOTE
Angular cutting cannot be done when adopting
chip cover or dust collector.
connectinG with cleaner
By connecting with cleaner (sold separately)
through dust collector and adopter (sold
separately), most of dust can be collected.
(1) Remove the allen wrench from the base.
(2) Move the base fully forward.
(3) Attach the chip cover with the shutter put
between the chip cover and gear cover.
(4) Connect the dust collector with adopter.
(5) Connect the adapter with the nose of
cleaner.
(6) Insert dust collector into the rear hole of the
base until the hook catches in the notch.
(7) Press the hook to remove the dust collector.
NOTE
Wear dust mask when possible.
selection of blaDes
To ensure maximum operating efficiency
and results, it is very important to select the
appropriate blade best suited to the type and
thickness of the material to be cut.
housinG the allen wrench
It is possible to house the auxiliary wrench on
the base.
Maintenance anD inspection
1. Inspecting the blade
2. Since use of a dull tool will cause motor
