Zener SMARTSTART 6000, Networking Manual

Page: 26 / 36

Zener Smartstart(R) 6000 Modbus Map For SS6K firmware V1.31
Reg No. Hex Adr Dec Adr Bit GROUP NAME / Data Item Name Regs Data Type Units Description. Also see Networking Guide (NG).
OPERATION STATUS 42 READ ONLY Dynamic Data
41071 0x042E 1070 Protection Threshold Flags . . . 1 Pre ‐ warning indication (e.g. threshold exceeded)
"
0
/ Starter Thermal Hot BOOLEAN 1 = starter too hot to start (Ts > reset temp.)
" 1 / Motor Thermal Hot BOOLEAN 1 = motor too hot to start (i2t TOL > reset level)
" 2 / Motor Overtemp Hot BOOLEAN 1 = motor too hot to start (thermistor > ~1k6 ohms)
" 3 / Alarm Input D1 Detect BOOLEAN 1 = trip input prewarning (e.g. low pressure)
"
4
/ Alarm Input D2 Detect BOOLEAN 1 = trip input prewarning (e.g. low flow)
"
5
/ Acceleration Overtime Detect BOOLEAN 1 = accel timer expired AND NOT up to speed
" 6 / Current Imbalance Detect BOOLEAN 1 = imbalance deteteced (prewarning)
" 7 / Motor Stall Detect BOOLEAN 1 = stall current detected (prewarning)
"
8
/ Motor Overcurrent Detect BOOLEAN 1 = heavy load detected (prewarning)
"
9
/ Motor Overtorque Detect BOOLEAN 1 = heavy load detected (prewarning)
" 10 / Motor Undercurrent Detect BOOLEAN 1 = light load detected (prewarning)
" 11 / Motor Undertorque Detect BOOLEAN 1 = light load detected (prewarning)
"
12 /
Voltage Imbalance Detect BOOLEAN 1 = imbalance deteteted (prewarning)
"
13 /
Brake Fault Detect BOOLEAN 1 = brake fault detected (prewarning)
" 14 / Reserved BOOLEAN
" 15 / Other Alarm Detect BOOLEAN 1 = Another alarm input condition is active
41072 0x042F 1071 Protection Warning Flags . . . 1 Pre ‐ trip "warning" indication
"
0
/ Starter Thermal Warning BOOLEAN 1 = thermal level above "Warn Level"
" 1 / Motor Thermal Warning BOOLEAN 1 = "
" 2 / Motor Overtemp Warning BOOLEAN 1 = near trip point (Rt > ~1k6 ohms)
" 3 / Alarm Input D1 Warning BOOLEAN 1 = trip timer greater than "Warn Delay"
"
4
/ Alarm Input D2 Warning BOOLEAN 1 = "
" 5 / Acceleration Overtime Warning BOOLEAN 1 = "
" 6 / Current Imbalance Warning BOOLEAN 1 = "
" 7 / Motor Stall Warning BOOLEAN 1 = "
"
8
/ Motor Overcurrent Warning BOOLEAN 1 = "
" 9 / Motor Overtorque Warning BOOLEAN 1 = "
" 10 / Motor Undercurrent Warning BOOLEAN 1 = "
" 11 / Motor Undertorque Warning BOOLEAN 1 = "
"
12 /
Voltage Imbalance Warning BOOLEAN 1 = "
"
13 /
Brake Fault Warning BOOLEAN 1 = "
" 14 / Reserved BOOLEAN
" 15 / Other Alarm Warning BOOLEAN 1 = Another alarm warning (see Warning Code)
SS6K_Modbus_Map_V1.31_I0055B 29/04/2020 APPENDIX A ‐ 2