24
24
Camera warning
The warning for Road Safety Cameras can be turned on in Warning Settings. Tap the following
buttons:
,
,
,
.
When you approach a Road Safety Camera with the warning enabled, the following happens:
x
Visible Warning: The type and distance of the camera is displayed in the secondary Turn
Preview field (for example
).
x
Audible Warning: If there is no speed limit specified for the camera, or your speed is under the
specified speed limit, single beeps warn you about the camera.
x
If you exceed the speed limit of the camera, the following also happens:
x
Visible Warning: A symbol with the speed limit appears in the corner of the map (for
example:
),
x
Audible Warning: A special alert sound is played.
2.3.10.1 Camera types
There are different types of Road Safety Cameras.
Icon
Type Description
Fixed
Some speed cameras stand by the roadside, looking in one direction,
measuring one or both directions of the traffic. They measure your current
speed. For these speed cameras you can specify the controlled traffic
direction and the speed limit. ZENEC Navigation Software warns you when
you approach these speed cameras in the measured direction. If your speed
exceeds the speed limit near the speed camera, ZENEC Navigation Software
plays a special warning sound.
Mobile
Some speed cameras are operated from vehicles. They do not always work
and they are not set to check a preset speed limit. The warning is similar to
fixed speed cameras, but as there is no speed limit given, only the proximity
is announced.
Built-in
Some speed cameras are built into traffic lights. They work like fixed speed
cameras, but they are difficult to spot. The warning for proximity and
speeding is the same as for the fixed speed cameras.
Section
control
These speed cameras work in pairs, and do not measure your current speed
but your average speed between the two speed cameras. Both identify your
car and record the exact time you pass them. They use the difference
between the two points in time to calculate your average speed.
ZENEC Navigation Software warns you when you approach one of these
speed cameras, but as you pass by, the warning stays on, and your average
speed is measured until you reach another speed camera of this type. If your
average speed exceeds the speed limit between the two speed cameras, you
receive the same special warning sound as with the other speed camera
types.
In the rare case ZENEC Navigation Software cannot register the moment you
pass the second speed camera (for example, it is placed at the exit of a
tunnel where GPS position is not yet available) the warning continues. Just
ZE-NA2000_UserManual_UK.indd 24
23.04.2009 10:43:13 Uhr
Summary of Contents for ZE-NC514
Page 79: ...79...
Page 150: ...72...
Page 151: ......
Page 152: ...1 CH DVB T TUNER ZE DVBT10 MODEL NO ZENEC By ACR AG Bohrturmweg 1 Bad Zurzach Switzerland...